Responce Format - RADWAG R Balances Serie Manual Del Usuario

PC
BN
FS
RV
A
EV
EVG
FIS
FIG
ARS
ARG
LDS
NT
CAUTION!
Each command must end with CR LF characters;

15.2. RESPONCE FORMAT

On receipt of a command, the terminal responds as follows:
XX_A CR LF
XX_D CR LF
XX_I CR LF
XX _ ^ CR LF
XX _ v CR LF
XX _ OK CR LF
ES_CR LF
XX _ E CR LF
Where:
XX - name of a sent command
_ - spaces
Commands Overview
Zero balance
Format: Z CR LF
Response options:
Z_A CR LF - command understood and in progress
Z_D CR LF - command carried out
Z_A CR LF - command understood and in progress
Z_^ CR LF - command understood but zeroing range is exceeded
Z_A CR LF - command understood and in progress
Z_E CR LF - time limit exceeded while waiting for stable measurement result
Z_I CR LF - command understood but not accessible at this moment
Tare balance
Format: T CR LF
Response options:
T_A CR LF - command understood and in progress
T_D CR LF - command carried out
T_A CR LF - command understood and in progress
T_v CR LF - command understood but taring range exceeded
T_A CR LF - command understood and in progress
T_E CR LF - time limit exceeded while waiting for stable measurement result
T_I CR LF - command understood but not accessible at this moment
Send all implemented commands
Give balance type
Give Max capacity
Give program version
Set autozero function
Set ambient conditions state
Give currently set ambient conditions
Set filter
Give current filter
Set value release
Give current value release
Set last digit
Cooperation with PUE 7.1, PUE 10 terminal
command understood and in progress
command carried out (appears only after the command XX_A)
command understood but not accessible at this moment
command understood but max threshold is exceeded
command understood but min threshold is exceeded
command carried out
command not recognised
time limit exceeded while waiting for stable measurement result
(time limit is balance characteristic parameter)
- 86 -