Shutting Down; Shutdown; Storage; Transport - Kärcher HDS 9/14-4 ST Manual Original

Ocultar thumbs Ver también para HDS 9/14-4 ST:
Tabla de contenido

Publicidad

Use the following nozzles if the pipe length is more than 20 m or
for more than 2 x 10 m high pressure hose NW8:
Dirt
Nozzle
Spray an-
gle
strong
0075
medium
2575
25°
light
4075
40°
Detergent dosing
– Detergents simplify the cleaning task. They are sucked in
from an external detergent tank.
– The basic model of the appliance is equipped with a dosing
valve (C). A second dosing device (dosing valve D) can also
be procured as special accessory. It is then possible to use
two different detergents.
– The dosing quantity is set at the detergent dosing valves (C
or D) at the operating panel. The set value corresponds to the
percentage share of the detergent.
– The outer scale is applicable while using undiluted detergents
(100% CHEM).
– The inner scale is appliance while using 1 +3 pre-diluted de-
tergents (25 % CHEM + 75 % water).
The following table gives the detergent consumption for the val-
ues on the outer scale:
HDS 9/14
Position
Detergent quantity [l/h]
Detergent concentration [%]
HDS 12/14
Position
Detergent quantity [l/h]
Detergent concentration [%]
The exact dosing depends on:
– Viscosity of the detergent
– Suction height
– Flow resistance of the high pressure pipe
If an exact dosing is required, then measure the detergent quan-
tity that is sucked in (for e.g. by sucking in from a measurement
beaker).
Note: For list of recommended detergents refer the chapter "Ac-
cessories".
Part no.:
Pressure
[MPa]
HDS 9/14
5.765-242
10
5.765-057
5.765-220
0.5
1
14...15 22...24 50
1.5
2.5
0.5
1
10...13 23...27 60
1
2
ATTENTION
Recoil [N]
There can be calcium deposits in the continuous heater if you use
the appliance without softeners.
If the softener tank is empty, the indicator lamp for protection
37
against calcification (H) begins to glow.
Figure 1 - Pos. 9
 Refill the softener tank with softener liquid RM 110 (2.780-
001).
DANGER
Danger of scalding by hot water. After the operation with hot wa-
ter or steam, the device must be operated with opened gun with
cold water for at least two minutes.
 If operating with hot water, set the thermostat (B) to the lowest
temperature.
 Use the appliance for at least 30 seconds without detergent.
 Turn the appliance switch (A) to "0".
 Shut off water supply.
 Activate trigger gun until device is pressure-less.
 Secure the hand spray gun using the safety catch so that it
doesn't open accidentally.
If the machine is not to be used for a longer period or if it is not
possible to save it in a frost-free environment, then you must take
the following measures (see chapter "Maintenance and care"):
 Drain water.
 Flush device with anti-freeze agent.
 Switch off the main switch and secure it or unplug the Cekon
plug.
CAUTION
Risk of injury and damage! Note the weight of the appliance in
case of storage.
ATTENTION
Protect the trigger from damage during transport.
5
CAUTION
Risk of injury and damage! Observe the weight of the appliance
5
when you transport it.
 When transporting in vehicles, secure the appliance accord-
ing to the guidelines from slipping and tipping over.
5
5
6
-
EN
Refilling the softener

Shutting down

After operation with detergent
Turn off the appliance

Shutdown

Storage

Transport

27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hds 12/14-4 st1.698-9171.699-9211.699-923

Tabla de contenido