Panerai LUMINOR MARINA Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
PANERAI LUMINOR MARINA
The Panerai Luminor Marina is a watch executed in a limited edition dedicated
to the boutiques. It is equipped with a high quality Swiss hand-wound
mechanical movement.
T
HE CASE
The case, obtained from a single block of metal, is made completely of AISI
316L stainless steel. Its manufacture involves a complex range of processes.
Starting from the initial block roughly shaped by stamping, a total of more than
60 further production processes take place before the finished product is
achieved. A series of quality checks carried out with highly sophisticated
instruments ensures the watch's exceptional resistance and accuracy.
The anti-reflective crystal is of sapphire, made from corundum, which is the
toughest material after diamond. Without any impurities, it is completely
transparent and virtually scratch-proof. The gently cambered crystal ensures
that the dial is completely visible and guarantees resistance at great depths.
The screw-in back is made of steel and is personalised with an image of the
city where the boutique is located. On the back of the case are engraved the
case number, the sequential number of the watch with the number of the
production, the material and the maximun depth of use.
The water-resistance of your watch, indicated on the back by the symbol
, is guaranteed to a pressure of 30 bar, which correspond to the
hydrostatic pressure exerted by a column of water on 1 square centimetre at
a depth of 300 metres under normal conditions. In these circumstances your
watch is therefore water-resistant to a depth of about 300 metres.
T
HE DEVICE PROTECTING THE CROWN (protected by trademark)
It protects the winding crown from shocks and accidental damage while also
helping to preserve water-resistance by locking the winding crown in its
16
closed position. The little sprung lever mounted on the bridge fixed to the case
brings axial pressure to bear on the rubber ring of the winding crown without
damaging it, thus forming a perfect seal.
T
HE MOVEMENT
The movement of the Luminor Marina is the calibre OP II. It is an hand-wound
mechanical movement of 16½ lignes with power reserve of 56 hours, 17
jewels, monometallic Glucydur
®
balance, 21,600 alternations/hour, Incabloc
anti-shock device. "Côtes de Genève" decoration on the bridges, blued steel
screws as in the best Swiss watchmaking tradition.
It is accompanied by the Chronometer Certificate issued by the Contrôle
Officiel Suisse des Chronomètres (C.O.S.C.).
Officine Panerai is not the owner of the trademarks Glucydur
®
and Incabloc
®
.
17
®

Publicidad

Tabla de contenido
loading

Tabla de contenido