Powercord; Using Extension Cords; Using Westinghouse Power Cord - Westinghouse WGen5500 Manual Del Usuario

All manuals and user guides at all-guides.com
OPERATION

POWERCORD

Using Extension Cords

Westinghouse Portable Power assumes no responsibility for the content within this table. The use of this table is the
responsibility of the user only. This table is intended for reference only. The results produced by using this table are
not guaranteed to be correct or applicable in all situations as the type and construction of cords are highly variable.
Always check with local regulations and a licensed electrician prior to installing or connecting an electrical appliance

Using Westinghouse Power Cord

Use the extension cord chart to determine the size
of the conductor for extension cord applications.
Determine the distance of the generator to the
appliance on the top line of the chart. Then select the
rated amperage of the generator on the left side of the
chart. Where the two meet is the size of the conductor
required for the application.
The WCG25 power cord is connected to the generator
at the 120/240 plug. The opposite end of the power
cord is a fan tail receptacle with 2 green receptacles
and 2 red receptacles. Each receptacle is rated at
120 volts AC. To balance the load on the generator's
alternator, use the red and green identifiers on the fan
tail receptacle. To keep the load balanced, connect
the loads so that both color receptacles are used. An 2
Green Dots
example is one in red and one in green. Do not connect
2 in red and none in green, or 2 in green and none in
red. If only one color receptacle is used with multiple
1
Red Dots
loads, the alternator may experience an unbalanced
load, causing undue vibration to generator.
- WCG25 Extension Cord
Westinghouse Portable Power | 15