Corghi EXACT LINEAR PLUS Manual De Uso página 63

➥ Rim diameter
Always: If toes are set in millimetres or inches,
the step for input of the rim diameter is always
activated.
On request: If toes are set in millimetres or
inches, the step for input of the rim diameter
is activated either by the operator or automati-
cally if the reference diameter is not available
in the databank.
➥ Caster measurement steering lock
Always activated: Caster measurement steering
lock always activated.
On request: Caster measurement steering lock
activated on request.
If adjustable: Caster measurement steering
lock only activated if at least one of the angles
that can be measured is adjustable (caster,
king pin, steering angle difference at 20° and
maximum steering angle).
➥ Rear axle
Always activated: Rear axle adjustment always
activated.
If adjustable: Rear axle adjustment only acti-
vated if at least one of the angles that can be
measured is adjustable (half toe, camber, total
toe, setback).
➥ Second steering
Always activated: Caster measurement second
steering lock always activated.
Automatic skip: Caster measurement second
steering lock not activated.
If adjustable: Caster measurement second
steering lock only activated if at least one of
the angles that can be measured is adjustable
(caster, king pin, steering angle difference at
20° and maximum steering angle).
➥ Measurement assistant
YES: The measurement help animations are
shown.
No: The measurement help animations are not
shown.
➥ 1/2 axle alignment
YES: 1 or 2 axle alignment selection procedure
active.
NO: 1 or 2 axle alignment selection procedure
not active.
➥ Data summary
Always activated: The data summary is always
displayed.
Operator's manual EXACT LINEAR
On request: The data summary is only dis-
played if activated with the appropriate icon.
➥ King pin caster
YES: The values are calculated and displayed.
NO: The values are not calculated and dis-
played.
➥ Chassis height before ROC
YES: The data related to chassis height is
entered before the ROC phase.
NO: The chassis height is entered after ROC.
➥ Ask to end the job
YES: A confirmation message is displayed if
the end of job icon is pressed.
NO: when the end of job icon is pressed, the
starting page will appear and any unsaved data
will be lost.
➥ Perform ROC
Always: ROC is always performed.
Manual skip: It is possible to skip the ROC
phase with the appropriate icon.
Automatic skip: ROC is always skipped.
➥ Push Mode ROC type
Professional: back to 60...then 30 then 0.
Standard: 30 - 0.
➥ Cal One-Touch
YES: Enables the Cal One-Touch device. Also
the connection port and the type of connection
should be enabled in the Assistant Set-up.
NO: Disables the Cal One-Touch device.
➥ Steering wheel offset
YES: Displays the steering wheel centring con-
trol page before the Cal One-Touch adjustment.
NO: Does not display the steering wheel cen-
tring control page before the Cal One-Touch
adjustment.
Wheel aligner
➥ Turntable enabling
Always: Electronic turntables for maximum
steering angle always enabled.
On request: Electronic turntables enabled with
the appropriate icon on the steering page.
Never: Electronic turntables for maximum
steering angle not enabled.
➥ Axis of reference
Symmetry: axis of symmetry is axis of reference
EN
63