Display Cluster (Depending On The Model; Optional) - Cub Cadet 17AWCBYT603 Instrucciones De Funcionamiento Originales

Tabla de contenido

Idiomas disponibles

Pushing the device

B1 B1

Switch the engine off.

Switch the parking brake off.

For this purpose, pull both gear release levers

out

and press them to the right

You can now push the device.

Note

Never tow the device. This can cause seri-

ous damage to the gears.

To continue driving, push both gear release levers

anti-clockwise (before starting up the engine) and

push them into their recess(es).

Display cluster

(depending on the model; optional)

Note

The indicators only come on when the en-

gine is running.

Note

occur at the same time, the oil change

indicator.

Depending on the model, the display cluster can

consist of the following elements:

Type 1

lock

Operating hour counter

When the ignition is switched on, the battery voltage

indicator is displayed for a short period, which then

changes to the operating hours indicator.

The operating hours are always counted except

for when the ignition key is in the "Stop" position or

when it is removed.

Maintenance indicator

Note

means: The total operating hours are

displayed.

Change the engine oil immediately (see engine

operating manual).

This indicator appears every 50 operating hours for

a period of 2 hours.

The engine oil level is too low.

If the indicator does not go out, switch the engine

off immediately and check the engine oil level (see

the engine operating instructions). Top up the oil if

required.

started and then go out again.

If you turn the ignition key to the

operating hours.

Charge the battery as quickly as possible.

It may be necessary to have the charging system

checked by a service centre for possible damage.

engine operating manual).

This indicator appears every 25 operating hours for

a period of 7 minutes.