Assembly - Cub Cadet 17AWCBYT603 Instrucciones De Funcionamiento Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 113
EN

Assembly

Note
To be able to move the device manually, the
gear release lever must be in the appropri-
ate position. Refer to the section "Operation
– Pushing the mower".
Setting up the steering column
Note
Only for devices where the steering column
has been folded down for transport.
Press the steering column forwards and out of the
transport position
until it latches into the bottom
position.
Note
The steering column can be set to various
heights. For more on this, please refer to
the section "Operation – Fitting the steering
column".
Installing the steering wheel
Remove cover cap [1] ([A] or [B] depending on
model) from the steering wheel.
Remove screw [2] and the washer [3].
Bring the wheels into a straight position.
Place the steering wheel on the steering shaft.
Put on washer [3] with curved side face up.
Fix the steering wheel using the screw [2].
Insert the cover cap [1] ([A] or [B] depending on
model).
Attaching the seat
Remove the screws and nuts on the seat
holder
.
Fix the seat support to the seat holder
the previously removed screws and nuts.
Place the cable holder of the of the seat contact
switch into the opening of the seat well.
Fold the seat down
14
using
.
Attaching the discharge flap on the cutter
deck
Remove the screws [1] and nuts [2] on the dis-
charge opening of the cutter deck
opening
using the screws [1] and nuts [2].
Note
(depending on the model), the transport lock
(safety plate or cable tie) must be removed
automatically.
Putting the battery into operation
DANGER!
caused by battery acid and gases emitted
by battery acid
Battery acid is corrosive. Immediately
clean all parts of the device splashed by
battery acid.
Do not smoke; keep burning and hot
objects away.
Charge batteries in a well ventilated and
dry room only.
There is a risk of a possible short circuit
when working with the battery. Do not
place any tools or metal objects on the
battery.
DANGER!
Risk of poisoning and injury from battery
acid
Wear safety goggles and protective
gloves.
Do not allow battery acid to come into
contact with skin.
If battery acid is sprayed in your face or
eyes, wash it off immediately with cold
water and seek medical attention.
If you have swallowed battery acid, drink
a lot of water and seek medical attention.
Store batteries out of the reach of
children.
Never tilt the battery, as battery acid may
run out.
Bring the remaining, unused battery acid
to your dealer or to a waste disposal
company.
Assembly
.
[3] to the discharge
769-12352A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

17aicbyq603

Tabla de contenido