Storage; Transport - Cub Cadet 17AWCBYT603 Instrucciones De Funcionamiento Originales

Storage

Set the cutter deck level from front to back
Note
First check the side cutter deck level.
Park the device on an even surface and switch the
parking brake on.
Bring the cutter deck to the middle height position.
Carefully turn the outer cutters parallel to the drive
direction.
Measure the distance between the ground and the
end of the right cutter.
The end of the front blade should be about 6-9 mm
lower than the rear. You may have to adjust the front
[1] as follows:
Release the locknuts [2] in an anti-clockwise
direction.
To set the level, turn the adjusting nuts [3].
Tighten the locknuts [2] in a clockwise direction.
Storage
Attention!
Damage to appliance materials
Store the device in a clean, dry enclosed space.
Protect the device from rust when storing it for
lengthy periods of time.
Protect the device from frost.
Clean the device and the grass catcher.
Wipe all metal parts down with an oily cloth or
spray them with oil to protect them from rust.
Charge the battery.
Remove the battery in the event of long-term
storage (e.g. over winter).
Charge up the battery every 6–8 weeks in the
event of long-term storage and before reinstalling.
Drain the fuel and shut down the engine – see the
engine manual.
Check the tyre pressure.
769-12352A

Transport

Note
The device is not approved for public thor-
oughfares in accordance with national road
legislation (StVO).
Short distances
Switch off the cutter deck before driving the
mower.
Prior to driving, put the cutter deck in the highest
position.
Drive the machine only short distances to change
its location of use.
Long distances
WARNING!
Danger posed by unstable and unsecured
ramps
Risk of serious injury to people and sever
damage to property
If you are transporting the device on a
the ramp is stable and secure.
WARNING!
Danger posed by inadequate fastening
Turbulence during transport
If you are transporting the device in a
trailer or lorry, fasten it and secure it
adequately.
Attention!
Environmental hazard due to leaked fuel
Do not transport the device in a tilted state.
Transport the device on a transport vehicle over
long distances.
Manually push the device in neutral into/onto the
transport vehicle. For this purpose, pull both gear
release levers out of the recess and press them
to the right.
Activate the parking brake and secure the device
against slipping.
EN
25