Starting The Engine; Stop The Engine - Cub Cadet 17AWCBYT603 Instrucciones De Funcionamiento Originales

Operation

Starting the engine

Note on the choke
The choke is used for starting the device
with a cold engine. Some models have no
choke. The engine is automatically set to
the particular starting process. Follow the
separate instructions in the engine operating
manual.
Open the fuel tap (if present, see engine manual).
Sit down on the driver's seat.
Switch the cutter deck off.
Switch the parking brake on.
Set the throttle to .
If the engine is cold, pull the choke / set the
throttle to .
Activate the ignition key
ignition lock):
Insert the ignition key into the ignition lock
Turn the ignition key to
starts running.
Release the ignition key.
The ignition key stays in the normal position
.
or
Insert the ignition key in the ignition lock and
press it downwards for at least 1.5 seconds
until the engine starts running
Release the ignition key.
The ignition key stays in the normal position.
(Mowing in a forward direction)
Note
A start attempt should take a maximum of
5 seconds. Wait 10 seconds before trying
again.
Note
The OCR function must not be activated
during the start process (see section "OCR
function).
Reset the choke / throttle slowly until the engine is
running smoothly.

Stop the engine

Set the throttle to the middle position.
Let the engine run for approx. 20 seconds.
Set the ignition key (model-dependent) to
or press the ignition key downwards and release it
.
Remove the ignition key.
769-12352A
[3] (depending on the
.
until the engine
/
.
Driving
WARNING!
Risk posed by abrupt starting, sudden
stopping and driving at an excessively high
speed.
Risk of accidents
Drive slowly and brake slowly.
Do not drive at excessive speed.
Be particularly careful when reversing.
Never change the direction of travel with-
When entering corners, always reduce
your speed and adjust the speed to the
turning radius (the tighter the corner, the
lower the speed).
Never adjust the steering column or the
driver's seat when in motion.
Never operate the device without the
cutter deck.
Attention!
Do not step on the forward or reverse pedal
while you are activating the brake pedal or the
parking brake is activated. This may damage the
gears.
Brake pedal
A
Forward pedal
B
Reverse pedal
C
Switch for parking brake/Speed control
E
Sit down on the driver's seat.
Start the engine.
Release the parking brake by pushing right
through the brake pedal and then releasing it
again.
To drive off, press on the accelerator [B] or [C]
Note
The further you step on the accelerator
pedal, the quicker the machine will go.
EN
17