Important - Cub Cadet Volunteer Manual Del Operador

6. Release brake pedal and apply pressure to the accelerator
pedal.
7. Release accelerator and apply brake pedal evenly and
firmly to slow down or stop.
Engaging 4x4 (If Equipped)
The 4x4 switch is located on the right side of the dash panel. See
4x4 Switch (All 4x4 Models Only) on page 11.
1. To engage; stop or slow vehicle speed, push up on the
switch. All four wheels will now continue to have power.
IMPORTANT: Engage the 4x4 feature as the first option
when stuck in mud or similar situation where two wheel
drive is ineffective at moving UV.
2. If still unable to move UV with the 4x4 engaged, disengage
4x4 by pushing down on the switch and engaging the
differential lock as described below.
Engaging Differential Lock
The differential lock lever is located in the center console
between the seats (bucket seat models Only). See Controls and
Features on page 9.
1. To engage; stop UV, place into NEUTRAL, and pull the lever
rearward. The differential will then lock and remain so until
it is disengaged, giving continuous power to both rear
wheels.
IMPORTANT: Engage the differential as the last option when
stuck in mud or similar situation or when the left and right side
wheels are turning at slightly different speeds.
WARNING:
or turf damage, drive slow when operating UV with
differential lock engaged as steering response is
noticeably reduced. Also, do not drive the UV with
the differential lock engaged on concrete, asphalt or
any high traction surfaces.
Disengaging Differential Lock
1. To disengage the differential lock; stop the UV, place in
NEUTRAL, and push the lever forward.
Raising & Lowering Cargo Box
WARNING:
injury from unintentional lowering of the cargo box,
be sure UV is on a level and stable surface and
parking brake is locked before raising cargo box.
Manual Lift
1. Park the UV safely on level ground and set parking brake.
2. Empty cargo by hand and unlatch cargo box by pulling up
on the cargo latch.
3. While holding the latch up, lift the cargo box.
4. Lower and allow cargo box to re-latch before operating UV.
Electric Lift (Optional)
1. Park the UV safely and turn key to the RUN position.
14 S 4— o
ection peration
To avoid transmission damage, injury,
To prevent the possibility of bodily
2. Raise cargo box by pressing and holding top of electric lift
switch. Release switch when box is at desired dump height
or when maximum height is reached.
NOTE: A ratcheting noise will indicate cargo box is at full
extension. The same noise will also be heard when cargo
box is at the full down position. If lift capacity of the power
lift is exceeded, a ratcheting will also be heard.
3. To lower cargo box, push on bottom of electric lift switch.
Turn ignition switch to the STOP position.
Dumping Load from Cargo Box
1. Back up the UV to the dump site and apply parking brake.
2. Unlatch the tailgate from the steel cargo box.
See "Figure 4-5".
1
Figure 4-5
3. If equipped with an aluminum cargo box, unlatch the
tailgate from the cargo box. See "Figure 4-6".
Figure 4-6
4. If using an electric lift, raise cargo box to dump load and
lower box when empty.
WARNING:
The center of gravity changes as a
loaded cargo box is raised. Do not allow rear wheel
to hang over the edge of a loading dock or ravine.
The cargo box weight may shift over center and UV
could tip over backwards.
2
2
1