Cub Cadet Volunteer Manual Del Operador página 23

4. To measure the new tire circumference, mark the ground
with the tire valve stem at the bottom. Roll the UV forward
until the tire makes one full rotation and mark the ground
again; measure the distance between the marks to get the
tire circumference. See Figure 5-14.
Tire Valve Stem
Tire Circumference
Figure 5-14
5. Replace the 76.25" circumference in the formula with the
new measurement, compute the new circumference and
input the distance into the Gauge Accessory.
Tire Circumference and Sensor Point Setting
Refer to Figure 5-15 for the following steps.
Figure 5-15
1. In the main screen, press down the mode button for three
seconds to enter the circumference setting.
2. Example; Now the tire circumference is 1300 m/m. In
setting screen, press the set button to move to the digit
you want to set.
3. Press the mode button to make the setting.
4. Press the set button to enter the sensor point setting.
5. Press the mode button to make the setting.
6. Press the set button to return to the main screen.
S 5 — M & a
ection aintenance
23
djuStMentS