Cleaning The Appliance; Replacing The Oven Light Bulb - Thermador Pro Grand Serie Manual De Uso Y Cuidado

Ocultar thumbs Ver también para Pro Grand Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If the user tries to enable a self-clean function in an
oven where the self-clean function has been
restricted, the oven lights will blink on and off in 2-
second intervals to indicate to the user that the
function is not available. User must turn the knobs to
OFF to cease the blinking lights.

Cleaning the appliance

9 CAUTION
Avoid cleaning any part of the range while it is hot.
The porcelain enamel finish is acid resistant, but not
acid proof. Acidic foods, such as citrus juices,
tomatoes, rhubarb, vinegar, alcohol or milk, should be
wiped up and not allowed to bake onto the porcelain
during the next use.
Use the mildest cleaning procedure that will do the
job efficiently and effectively. Some cleaners of the
same type are harsher than others. Try on a small
inconspicuous area first.
Always rub metal finishes in the direction of the polish
lines for maximum effectiveness and to avoid marring
the surface.
Use only clean soft cloths, sponges, paper towels,
fibrous brushes, plastic, non-metal or steel wool soap
pads for cleaning and scouring, as recommended on
the chart.
Most exterior parts of this appliance can be cleaned
with hot sudsy water (except the various items
specifically identified otherwise). When rinsing is
required, rinse thoroughly.
Always wipe dry immediately to avoid water marks.
DO NOT USE CHLORINE BASED CLEANERS.

Replacing the oven light bulb

9 CAUTION
The light socket is live when the door is open. Make sure
the appliance and lights are cool and power to the
appliance has been turned off before replacing the light
bulb(s). Failure to do so could result in electrical shock or
burns. The covers must be in place when using the
appliance.
Use only 10W, 12V G4 light bulbs. Use a clean, dry cloth to
handle the light bulbs. This will increase the life of the
bulb.
Replacing the light bulb
1. Turn off circuit breaker.
2. Remove the oven racks.
3. Slide the tip of a flat blade screw driver between the
holder clip and the lamp housing (figure, a).
4. Support the glass lens cover with fingers along the
bottom edge to prevent the cover from falling to the
bottom of the oven. Gently twist the flat blade screw
driver to loosen the glass lens cover.
5. Remove the glass lens cover.
6. Remove the bulb by grasping and sliding the bulb
straight back until the two prongs have cleared the
ceramic holder (figure, b).
7. DO NOT touch the glass of the new replacement bulb
with your fingers. It may cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean
dry cloth. Locate the two prongs in the ceramic
holder, gently poking until the two prongs locate in
the ceramic socket.
8. Press down to seat the bulb (figure, c).
9. Slide the protective lens into the holder clip and push
the other end until the fixing clip snaps back into the
housing (figure, d).
a
b
c
d
10. Turn on circuit breaker.
29

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido