Kärcher KM 100/100 R P Manual página 28

 Rear sealing strip
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 5 and 10 mm.
 If worn, replace.
 Remove roller brush.
 Unscrew retaining nuts for rear sealing
strip.
 Screw on new sealing strip.
 Side sealing strips
 Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
 Screw on new sealing strip without fully
tightening the nuts.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
 Adjust sealing strip.
 Tighten nuts.
 Screw on side panels.
 Push in the waste containers on both
the sides and lock them.
Replacing dust filter
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Turn main key to "0" and remove it.
 Open the hood, insert retaining rod.
 Pull out the filter holder to the maximum
possible extent and lock.
 Remove the lamella filter.
 Insert new filter.
 Make sure driver engages with holes on
drive side.
 Lock the handle of the filter cleaner
back into place.
Note: Make sure when installing the new
filter that the fins are not damaged.
Replacing filter case seal
 Lift filter case seal out of groove in the
cover.
 Insert new seal.
Checking drive belt
 Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.
EN
10
-
 Check tension, wear and damages on
the V-belt of the sweep roller drive.
Check cup seal
 Chek the cup seal at the suction blower
regularly to see that it sits properly.
Replacing fuses
 Loosen screws on both sides of the
panel.
 Replace defective fuses.
 Replace front panel.
Note: Only use fuses with identical safety
ratings.
Check engine oil level and top up, if re-
quired
Note
The engine is equipped with an oil deficien-
cy switch. When the fill level is insufficient,
the engine switches off and can only be re-
started once the engine oil has been re-
plenished.
Danger
Risk of burns on account of hot surfaces!
 Allow engine to cool down.
27