Midea MAW12HV1CWT Manual Del Usuario página 17

ELECTRONIC CONTROL OPERATING INSTRUCTIONS
1 2
Operation buttons
1 ON/OFF button
Press ON/OFF button to turn unit
on or off.
NOTE: The unit will automatically
initiate the Energy Saver function
under cool, Dry, and Auto modes.
2
ECO button
Press ECO button to initiate this
function. This function is available
on COOL, DRY, and AUTO (only
AUTO-COOLING and AUTO-FAN)
modes. The fan will continue to run
for 3 minutes after the compressor
shuts off. The fan then cycles on
for 2 minutes at 10 minute intervals
until the room temperature is above
the set temperature, at which time
the compressor turns back on and
Cooling Starts.
Press ECO button for 3 seconds to
initiate the filter feature. This feature
is a reminder to clean the Air Filter for
more efficient operation. The LED (the
light above the button) will illuminate
after 250 hours of operation.
3
FAN button
Press Fan button to select the Fan
Speed in four steps-Auto, Low, Med or
High. Each time the button is pressed,
the fan speed mode is shifted. For
some models, the fan speed can not
be adjusted.
3 4
4
buttons
Press or
temperature setting.
NOTE: Press or hold either
button until the desired temperature is
shown on the display. This temperature
will be automatically maintained
anywhere between 60°F (16°C) and
86°F (30°C). If you want the display to
read the actual room temperature, see
"To Operate on Fan Only" section."
5 MODE button
To choose operating mode, press the
MODE button. Each time you press
the button, a mode is selected in a
sequence that goes from Heat, Auto,
Cool, Dry and Fan. The indicator light
beside the button will be illuminated
and will remain on once that mode is
selected. The unit will automatically
initiate the Energy Saver function
under Heat, Cool, Dry, and Auto (only
Auto-Cooling and Auto-Fan) modes.
1. To operate on Auto feature:
• When you set the air conditioner
to Auto mode, it will automatically
select cooling or fan only operation,
depending on what temperature
you have selected and the current
room temperature.
• The air conditioner will control the
roomntemperature automatically
based on thentemperature you set.
• In this mode, the fan speed cannot
be adjusted, it starts automatically
at a speed according to the room
temperature.
5 6
button to change
or
 Page 17 
7