Midea MAW12HV1CWT Manual Del Usuario página 22

Problem Solution
Air conditioner Dirty or restricted air filter. Clean air filter.
turns on and
Outside temperature extremely hot. Set FAN speed to a higher
off rapidly.
setting to bring air past cooling coils more frequently.
Check for potential obstructions blocking the outdoor intake/
exhaust. Clear any obstructions.
Air movement sound. It is normal to hear the airflow. If too loud, set to a
slower FAN setting.
Noise when
unit is cooling.
Window vibration - poor installation. Refer to installation
instructions or check with installer.
Water dripping Improper installation. Tilt air conditioner slightly to the outside to
INSIDE when allow water drainage.
unit is cooling. Refer to installation instructions - check with installer.
Water dripping
Unit removing large quantity of moisture from humid room. This is
OUTSIDE when
normal during excessively humid days.
unit is cooling.
Remote sensing Remote control not located within range. Place remote control
deactivating within 26 feet (8 m) and pointed in the general direction of the air
prematurely conditioner unit.
(some models).
Remote control signal obstructed. Remove obstruction.
Room too cold. Set temperature too low. Increase set temperature.
Noise when A "da-da" sound may occur for thirty seconds when the unit is
unit starts. turned on due to the compressor starting. It is normal.
Heat mode
does not start Wait for the outdoor temperature to rise above the minimum heat
or the machine pump operating temperature.
displays 'LO'
Unit will not For additional support and troubleshooting tips, follow the link in
connect to this QR code:
WiFi or App
does not work
(some models).
 Page 22 