Cleanup; Overnight Storage; Long Term Storage - Titan AirCoat 0508074A Manual Del Propietário

cleanup

Overnight Storage

Shutdown
1. Turn the pressure control knob
counterclockwise to the minimum
setting.
2. Turn the PRIME/SPRAY valve to
PRIME.
3. Move the pump ON/OFF switch to
the OFF position.
4. Move the compressor ON/OFF
switch to the OFF position.
5. Wait a couple seconds, then
trigger the gun into the material
container to release built up
fluid pressure from the pump and air pressure from the
compressor.
6. Lock the gun by flipping the trigger lock into lock position
(see spray gun manual).
7. Unplug the unit.
8. For latex materials only, pour 1/2 cup water slowly on the
top of the paint to prevent the paint from drying. For other
materials, seal the material container keeping the return
hose in the paint.
9. Wrap the spray gun assembly in a damp cloth and place it
in a plastic bag. Seal the bag shut.
10. Place the unit in a safe place out of the sun for short-term
storage.
Startup
1. Remove the gun from the plastic bag.
2. Stir the water into the paint for latex materials. Remove
the cover from the material container and stir the paint for
all other materials.
3. Perform the appropriate procedure in the "Painting"
section of this manual for the type of spraying that will be
performed.
English
Long-Term Storage
PRIME/SPRAY
Valve
NOTE: If spraying with latex paint, use warm soapy
IMPORTaNT: Do not use mineral spirits or paint thinner on
latex paint, or the mixture will turn into a jelly-like substance
which is difficult to remove.
Pressure
Control Knob
clearing the Paint hopper
Use the following procedure to clear the material out of the paint
hopper of a hopper unit.
1. Lock the gun by flipping the trigger lock into lock position
2. Turn the pressure control knob counterclockwise to the
3. Turn the PRIME/SPRAY valve to PRIME.
4. Move the motor ON/OFF switch to OFF.
5. Direct the return tube into the original material container.
6. Move the motor ON/OFF switch to ON.
7. Turn the pressure control knob to 1/2 maximum pressure.
8. Turn the pressure control knob counterclockwise to the
9. Trigger the gun to relieve pressure and lock the gun.
10. Remove the spray tip and guard and place them into a
11. Fill the paint hopper with water or an appropriate solvent
12. Direct the return tube into a waste bucket.
13. Increase the pressure to 1/2 the maximum pressure. Let
8
Do not allow paint to build up on the motor or the
motor will overheat. Do not allow flammable
solvents to come in contact with the motor or they
could ignite.
water for cleaning. If using oil or alkyd-based
paints, use mineral spirits or paint thinner.
(see spray gun manual).
minimum setting.
This will draw the remaining material in the paint hopper
through the pump, up the return tube, and into the material
container.
minimum pressure setting.
container of water or appropriate solvent for the type of
material with which you are painting.
for the type of material with which you are painting.
the water or solvent circulate for 2-3 minutes to flush
material out of the pump, the paint hopper, and the return
tube.
© Titan Tool. All rights reserved.