Replacing The Fill Valve; Adjusting The Water Level - Toto AQUIA IV CST446 Serie Manual De Instrucciones Y Del Propietario

1. Shut off the water supply. Flush the toilet
and remove any remaining water from the
tank. Reverse the tank installation instruc-
tions to remove it from the bowl. Remove
2.
ed portion of the shaft through the hole
in the bottom of tank.
3. Thread mounting nut onto exposed shaft
under the tank and tighten nut.
Do not over-tighten.
CAUTION
4. Connect the water supply (see ill. 1). Pipe
dope is not recommended. Attach the
Refer to the water level line stamp inside the
tank.
1. The water level adjustment is located
adjustments:
• To raise the water level: turn the
screwdriver clockwise, or towards
the '+' indicator.
• To lower the water level: turn the
screwdriver counter-clockwise, or
towards the '-' indicator.
2. Flush after each adjustment to check

REPLACING THE FILL VALVE

ADJUSTING THE WATER LEVEL

ill. 1
-
ill. 1
8
Washer
Nut
Cone seal
Coupling nut
Flexible hose
water level adjuster