Interrupting The Automatic Convergence Process; Error Messages - Barco IRIS2 Manual De Ajuste

Align on all sources
When ALIGN is selected, the automatic convergence on all sources
will be adjusted automatically, based on the existing settings.
By projecting alternately red and blue lines, 25 convergence areas
are aligned on the green pattern. The process will repeat for as many
times as there are sources.
Follow the steps below to select :
K
highlight the ' ALIGN' below ON ALL SOURCES by pushing the
control stick forward or backward;
K
press Enter to start up the automatic convergence of the entire
screen.
If the process is successfully completed, the projector will return to
image display of the current source.
Use this option when the state of convergence is close to the right
alignment.
Align from midposition on all sources
When 'ALIGN FROM MIDPOSITION' is selected, the automatic
convergence on all sources will be adjusted automatically, but
starting from the midposition settings.
By projecting alternately red and blue lines, 25 convergence areas
are aligned on the green pattern. The process will repeat for as many
times as the number of the sources until all sources are perfectly
aligned.
Follow the steps below to select :
K
highlight ' ALIGN FROM MIDPOSITION' below ON ALL
SOURCES by pushing the control stick forward or backward;
K
press Enter to start up the automatic convergence of the entire
screen.
If the process is successfully completed, the projector will return to
image display of the current source.
Use this option when the state of convergence is far away from the
right alignment.

Interrupting the automatic convergence process

The process of the above-mentioned automatic convergences can
be interrupted at any moment by pressing the <EXIT> key.
After EXIT is pressed, the projector will leave the automatic conver-
gence process and a message will be displayed informing the action
:
Status : Forced <EXIT>

Error messages

The status line in the AUTOCONVERGENCE menu can give four
possible messages :
K
Ready : before automatic convergence starts;
K
Forced <EXIT> : when interrupting the process;
K
No pattern : error message;
K
Forced break : error message.
Error messages are displayed when the automatic convergence is
not successfully completed.
2
5975477 IRIS 211196
On-screen operating instructions
AUTOCONVERGENCE
ON CURREFNT SOURCE :
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES : (10)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
AUTOCONVERGENCE
ON CURREFNT SOURCE :
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES : (10)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Status : Ready
é
ê
Select with or
then <ENTER> ;
<EXIT> to return
AUTOCONVERGENCE
ON CURREFNT SOURCE :
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES : (10)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
AUTOCONVERGENCE
ON CURREFNT SOURCE :
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES : (10)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Status : Ready
é
ê
Select with or
then <ENTER> ;
<EXIT> to return
AUTOCONVERGENCE
ON CURREFNT SOURCE :
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
ON ALL SOURCES : (10)
TOUCH-UP
ALIGN
ALIGN FROM MIDPOSITION
Status : Forced <EXIT>
é
ê
Select with or
then <ENTER> ;
<EXIT> to return
11