Fein GRIT GX75 Manual De Instrucciones página 15

Daily maintenance
Blow out the ventilation slots (16) at the motor
housing and the marked locations with com-
pressed air (see Instruction label (25)).
Lubricate the machine daily (when in use) with
machine oil at the locations marked (see Instruc-
tion label (25)).
Check the drive disc (21) and the contact disc (19) for
wear and damage each time when replacing a grinding
belt. Have damaged parts replaced.
Loosen star-knob bolt (12).
Remove the chip/grinding-dust box (11) and dispose of
the metal dust.
Before emptying, the contents of the chip/grinding-dust
box must have cooled down sufficiently and may only
be disposed of in suitable containers.
Mount the emptied chip/grinding-dust box again and
set the gap clearance of the grinding rest.(figure 4)
Tighten star-knob bolt (12).
Cleaning the exterior of the machine with compressed
air.
If required, you can change the following parts your-
self: Grinding belt, spark guard (9)
Warranty and liability.
The warranty for the product is valid in accordance
with the legal regulations in the country where it is mar-
keted. In addition, FEIN also provides a guarantee in
accordance with the FEIN manufacturer's warranty dec-
laration.
The delivery scope of your machine may include only a
part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
This CE declaration is only valid for European Union
and EFTA (European Free Trade Association) countries
and only for products intended for the EU- or EFTA
market. After placing the product on the EU market the
UKCA mark loses its mark validity.
The UKCA declaration is only valid for the Great
Britain market (England, Wales and Scotland) and only
for products intended for the Great Britain market.
After placing the product on the Great Britain market
the CE mark loses its mark validity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the
last page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH,
D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out machines and accessories should
be sorted for environment-friendly recycling.
Connection diagrams.
Type GX75
Type GX752V
Type GX752H
Type GX752H2V
en
Page 99
Page 100
Page 101
Page 102
15