Deleting Nuisance Channels; Restoring A Nuisance Channel; Selecting Channels; Channel Error Messages - Motorola Solutions APX NEXT Guia Del Usuario

7.2.3

Deleting Nuisance Channels

If a channel continually generates unwanted calls or noise (termed "nuisance" channel), you can
temporarily remove the unwanted channel from the scan list. This capability does not apply to priority
channels or the designated transmit channel.
Procedure:
From the Home screen, tap
7.2.4

Restoring a Nuisance Channel

Procedure:
To restore the deleted nuisance channel, perform one of the following actions:
• Stop and restart a scan.
• Mode change to another channel and back to the original channel.
• Turn off the radio and then turn it on again.
7.5

Selecting Channels

Procedure:
Use one the following methods to select a channel:
If...
7.5.1

Channel Error Messages

If there is a channel error, your radio displays error messages on the Radio Control Widget.
Type
Unprogrammed
Fail 001
Nuis Del.
Then...
Rotate the Channel Selector to the required position.
a From the Home screen, tap the Radio Control Widget.
b Perform one of the following actions:
a On the Channel tab, select the required channel.
b On the Recents tab, select the recently used zone and
channel.
c To search for the required channel, tap
Description
The mode is set to an unprogrammed channel.
The selected channel is assigned to an incorrect frequency band.
MN005642A01-AP
Chapter 7 : General Radio Operation
Search.
45