Operation And Installation - THERMEx Cyclone Manual De Instrucciones

M 525231082215092021 THERMEX CyCLONE 73

OPERATION AND INSTALLATION

The instructions in this manual must be followed carefully. No liability is accepted for possible defects, damage or fires on the unit, caused due
to non-compliance with the rules in this manual. The hood is intended for use in private households only.
! It is important to keep this manual so that you can refer to it at any time. In case you are selling, passing on or moving the device, be sure to
keep the manual and the device together.
! Read the operating instructions carefully: it contains important information on installation, use and safety.
! Do not make electrical or mechanical changes to the product or to the wires.
Note: Some of the parts described in the manual are not included. Parts not included in the package can be purchased separately.
IN CASE OF TRANSPORT DAMAGE:
Visible transport damage to the outer packaging or to the delivered goods must already be observed upon receipt of the goods and registered
on the transport company's transport documents and confirmed by the driver. Subsequent complaints are excluded!
Please report hidden transport damage in writing immediately after the discovery (e-mail) with photos, but no later than 7 days after receipt
of the item.
Function test before installation!
1. Before installing the appliance, perform a function test (motor, etc.)
2. In the event of a defect, do not install the unit. Report the error to us immediately.
3. Check the surface of the device before installation. In case of complaints, the device must not be installed or all warranty claims will expire
automatically.
4. If the unit is still installed, the dealer / end customer undertakes to return the component in question and replace it himself, provided that
we recognize this as a defect.
5. you only have a factory warranty if the exhaust air connection to the unit is at least 150 mm pipe diameter. There must also be no constrictions
in the pipe system.