Commissioning - SOMFY Sonesse Ultra 50 RTS Manual

2.3. COMMISSIONING

2.3.1. Pre-programming the RTS control point
1) Switch on the power supply.
2) Press the and
control point is pre-programmed in the motor.
2.3.2. Checking the direction of rotation
1) Press the
entitled "Setting the end limits".
2) Press the my button on the RTS control point
3) Press the button on the RTS control point to
2.3.3. Setting the end limits
The end limits can be set in any order.
1) Raise the motorised product to the desired position
by pressing the button.
2) Press the my and
The upper end limit is memorised.
3) Press the my button when the motorised product
V
and buttons.
4) Press the my and
The lower end limit is memorised. The motorised product rises and stops in the raised position.
2.3.4. Validation of the setting
The end limits are programmed.
Copyright © 2014 - 2017 Somfy SAS. All rights reserved.
V
buttons on the RTS control
V
buttons at the same time until
buttons at the same time until
my button until
1
1)
a
=
b
=
2)
1)
3)
Images not contractually binding
EN
2
3)
2)
4)
5