Kärcher HDC 60/10 Advanced Manual De Instrucciones página 15

Please read and comply with these origi-
nal instructions prior to the initial opera-
tion of your appliance and store them for
later use or subsequent owners.
– Before first start-up it is definitely necessary to read
the safety indications Nr. 5.956-309.0!
– In case of transport damage inform vendor imme-
diately.
Contents
Environmental protection
Danger or hazard levels
Symbols on the machine
Safety instructions
Proper use
Function
Safety Devices
Device elements
Start up
Operation
Shutdown
Technical specifications
Transport
Storage
Care and maintenance
Troubleshooting
Accessories
Installing the plant
EU Declaration of Conformity
Warranty
Customer Service
Environmental protection
The packaging material can be recycled.
Please do not throw the packaging mate-
rial into household waste; please send it
for recycling.
Old appliances contain valuable materials
that can be recycled; these should be sent
for recycling. Batteries, oil, and similar
substances must not enter the environ-
ment. Please dispose of your old appli-
ances using appropriate collection sys-
tems.
Please do not release engine oil, fuel oil, diesel and
petrol into the environment Protect the ground and dis-
pose of used oil in an environmentally-clean manner.
Kärcher detergents are easy-to-dispose. This means
that the functioning of an oil separator is not hampered.
Please find a list of recommended detergents in the
chapter "Accessories".
Notes about the ingredients (REACH)
You will find current information about the ingredients
at:
www.kaercher.com/REACH
Danger or hazard levels
DANGER
Pointer to immediate danger, which leads to severe in-
juries or death.
WARNING
Pointer to a possibly dangerous situation, which can
lead to severe injuries or death.
CAUTION
Pointer to a possibly dangerous situation, which can
lead to minor injuries.
EN 1
ATTENTION
EN 1
Pointer to a possibly dangerous situation, which can
EN 1
lead to property damage.
EN 1
Symbols on the machine
EN 1
EN 2
EN 3
EN 4
EN 5
EN 5
EN 5
EN 6
EN 8
Safety instructions
EN 8
EN 8
– Please follow the national rules and regulations for
EN 9 fluid spray jets of the respective country.
– Please follow the national rules and regulations for
EN 10
accident prevention of the respective country. Fluid
EN 11
spray jets must be tested regularly and the results
EN 11
of these tests must be documented in writing.
EN 11
– Please follow the safety instructions which are at-
EN 12
tached to the used detergents (normally on the
packing label).
The work station is located at the display. Depending on
the plant installation, other work-stations are located at
the accessories (spraying units) that are connected to
the feeder points.
Personal safety gear
– Wear protective clothing and safety goggles to pro-
tect against splash back containing water or dirt.
Risk of burns! Beware of hot com-
ponents.
Work-stations
Wear ear plugs to protect your
ears against hearing loss while
cleaning parts that produce high
sound levels.
1
-
EN
Proper use
– This system transports water to the down-the-line
high pressure units with high pressure. This unit is
permanently installed in a dry room. There must be
a water and a power connection present according
to the details provided in the technical specifica-
tions. The temperature at the installation site
should not exceed 40 °C. The high pressure water
is distributed through a fixed network of pipes.
– Only clean water may be used as high pressure
medium. Impurities will lead to increased wear and
tear or formation of deposits in the appliance.
– Above 15 °dH, measures for hardness reduction
may become necessary.
– The use of recycled water must be prearranged
with Kärcher in advance.
DANGER
Risk of injury! Follow the respective safety regulations
when operating at gas stations or other dangerous are-
as.
Please do not let mineral oil contaminated waste water
reach soil, water or the sewage system. Perform en-
gine cleaning and bottom cleaning therefore only on
specified places with an oil trap.
15