diversey TASKI swingo 2500 Manual De Instrucciones página 10

Relocation drive
The driving direction can be controlled with the steering wheel and the
speed with the gas pedal. The speed is continuously regulated.
When the gas pedal is released, the machine decelerates until it stops
and the parking brake is activated.
Driving forward
• Switch on the machine (key switch).
• All indicator elements light up briefly.
The battery level indicator notifies
you that the machine is ready for op-
eration. (In case of malfunctions,
please see page 15).
• To drive forward, you only need to press the gas pedal.
Notice:
The speed is electronically reduced for driving
around corners.
Reversing
• When the reversing button is activat-
ed, the indicator below lights up and
an acoustic signal is emitted.
Notice:
When reversing in working operation, the supply of
the cleaning solution will be interrupted.
The squeegee will not be lifted.
Moving the machine (in case of defect)
Notice:
Generally, the machine should only be moved in
pairs.
Warning:
Due to its heavy weight, moving the machine man-
ually is very risky!
Missteps can lead to personal injury and damage to the
machine.
• It can only be moved once the release button/lever is acti-
vated. (See page 5)
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
• Remove the key and actuate the stopping brake.
• Lift up the tools towards the coupling.
• Turn the tools into the coupling; the
left tool in counter-clockwise direc-
tion, the right tool in clockwise direc-
tion.
The tools are coupled.
Suction nozzle assembly
• Remove the key and actuate the stopping brake.
• Hold the nozzle in both hands and
position it such that the nozzle holder
lugs (1) fit into the nozzle cut-outs
(2).
1
1
2
2
• Slide the nozzle upwards until the in-
terlocking clips (3) lock in place with
an audible sound.
3
• Assemble both suction hoses onto the suction nozzles.
Filling the fresh water tank
Caution:
Max. permissible water temperature 60 °C/140 °F.
- Diversey recommends using cold water, as hot water
will adjust to the ground temperature as soon as it
comes into contact with the ground. Thus there are no
advantages to using hot water.
• Remove the key and actuate the stopping brake.
• Fold the driver seat forwards and open the tank cover.
• Take out the dosing cup from the fresh water tank (Flex-
tank).
• Fill water into the fresh water tank
(Flextank).
The mark indicates the maximum
permissible filling level.
Dosing
Caution:
Wear gloves, goggles and appropriate (protective)
working clothes when handling chemical products!
Notice:
Use chemical products recommended by Diversey
only and always observe the product information.
Caution:
The use of inappropriate products (e.g. products
containing chlorine or acid) may damage or destroy
the machine.
Dosing examples:
9