Attaching The Fan Blades - Kichler 56 Salvo Manual De Instrucciones

ATTACHING THE FAN BLADES

CAUTION: To Reduce The Risk Of Electric Shock, Disconnect The
Electrical Supply Circuit To The Fan Before Installing Fan Blades.
Step 1. Position the screw, screw cap and nut to the blade as shown,
tighten the blade with the screw. Then, screw the nut cover to screw
cap securely. Do not over tighten. (Fig. 10)
Repeat for the other blades.
Step 2. Carefully slide the blade assembly through the slot as shown,
make sure the blade assembly is fully seated against the blade holder
on the motor assembly. Securely tighten the blade with three screws
found in hardware pack. (Fig. 11)
Repeat for the other blade assemblies.
Step 3. Position the flywheel décor over the motor as shown, align the
holes on the flywheel décor with the holes on the motor assembly,
and make sure five arms are positioned into the holes of grommets
on nut covers correctly, securely tighten with five screws found in
hardware pack. (Fig. 12)
Screw
Screw Cap
Blade
Nut
Fig. 10
Fig. 12
Nut Cover
Blade Holder
Fig. 11
Screw
Arm
56" Salvo | 9