Attaching The Fan Blades - Kichler 56 Crescent Manual De Instrucciones

ATTACHING THE FAN BLADES

CAUTION: To Reduce The Risk Of Electric Shock, Disconnect The Electrical
Supply Circuit To The Fan Before Installing Fan Blades.
Step 1. Position the blade over the blade bracket with the threaded post
showing. Make sure the bottom edge of the blade is fully seated against the
blade bracket. Place blade cover on top of the blade, positioning the holes over
the threaded posts. Tighten with three screws from the hardware pack to secure
the blade to the blade bracket. (Fig.18)
Repeat for the remaining blades.
Step 2. Fasten blade assembly to the holes located on the bottom of the
flywheel. Tighten the two pre-installed motor screws in the blade bracket.
Repeat steps for the remaining blade assemblies. (Fig.19)
INSTALLING THE LIGHT PLATE
Step 1. Remove the screw marked with a brown dot label on the mounting
plate and keep for later use. Loosen the other two (do not remove).(Fig.20)
Blade Screw
Blade Cover
Blade
Blade Bracket
Fig. 18
Mounting Plate
Screw
Fig. 20
Blade Assembly
Fig. 19
56" Crescent | 13