Attaching The Fan Blades; Installing The Switch Housing - Kichler 330160 Manual De Instrucciones

ATTACHING THE FAN BLADES

CAUTION: Remove the rubber shipping blocks attached to the face
of the motor. These blocks keep the motor from shifting during
shipping and MUST be removed during installation.
Step 1. Attach the blade to the blade bracket using the screws and
washers as shown in Figure 14. Start screw into bracket. Repeat for
the two remaining screws.
Step 2. Make sure the blade is straight and tighten each screw.
Step 3. Fasten blade assembly to motor using "Pre-Installed"
mounting screws in the blade bracket.

INSTALLING THE SWITCH HOUSING

NOTE: Before continuing installation, confirm that the power is still
turned off at the main circuit breaker or by removing the correct
fuse. Turning the power off using a wall switch is not sufficient to
prevent electrical shock.
Step 1. While holding the switch housing under your ceiling fan, push
the square wire connectors together. One from the fan and one from
the switch housing. (Fig. 15)
NOTE: These connectors are color coded and will ONLY engage
when the colored strips are matched (aligned).
Step 2. Carefully push all the wires into the switch housing. Attach
the switch housing to the mounting ring with the screws provided.
Make sure each screw is tight. (Fig. 15)
14
| KICHLER.COM
Blade arm
Screw
Blade arm
Mounting ring
Wire connector
Screws
Switch housing
Fob
Screw
Washer
Blade
Fig. 14
Fig. 15