Use - Imetec TITANOX H3902 Instrucciones De Uso

GB

USE

FILLING THE RESERVOIR
Verify that the plug (11) is disconnected from the socket.
Set the steam selector (5) to 0 [Fig. B].
Open the water fill cover (6).
Set the iron in a position that facilitates filling the water and prevents it from overflowing.
Slowly pour the water into the reservoir (10) using the special cup (12) [Fig. C].
Do not exceed the maximum fill-up level (8) indicated on the reservoir (10).
Close the water fill cover (6).
SELECTING THE TEMPERATURE
Set the iron upright.
Insert the plug (11) in the socket.
Set the temperature according to the type of fabric in line with the international symbols
shown on the labels; using the adjustment knob (2), [Fig. D].
Consult the table below for the correct temperatures.
The plate temperature LED (1) indicates that the iron is warming up.
Wait for the plate temperature LED (1) to go off before starting to iron.
Garment Type of Temperature
label fabric setting
synthetics
e.g. viscose, polyester.
silk, wool.
cotton, linen.
ECO FUNCTION
The appliance is equipped with technology that optimises the steam production, thereby
reducing energy consumption.
Set the steam selector (5) to ECO to activate the function.
It is recommended to use the ECO function for delicate garments (silk, wool and light cotton).
Follow the instructions in the "steam ironing" section, leaving the steam selector (5) set to 0.
IRONING WITH STEAM
Select the amount of steam via the steam selector (5).
Move the steam selector (5) to any position between minimum and maximum according to
the desired amount.
Continuous steam will only be dispensed when the iron is in a horizontal position.
This stops when the iron is set upright or the steam selector (5) is set to 0.
Steam can only be used at the highest temperatures, as indicated by the symbol on the
temperature adjustment knob (2) [Fig. D].
If the selected temperature is too low, water droplets may drip from the plate.
15
MI001087.indd 6 26/01/13 12.23