Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Indicating a Plumb Line/Vertical Plane
(see figure B)
To indicate a plumb line or a vertical plane,
set up the laser tool in the vertical position.
When the vertical plane is supposed to run at a
right angle to a reference line (e.g. a wall), then
align the plumb beam
line. The plumb line is indicated by the rotating
14
laser beam
.
Working without Laser Detector
(see figure C)
Under favorable light conditions (dark environ-
ment) and for short distances, it is possible
to work without the laser detector. For better
visibility of the laser beam, either select line
operation, or select point operation.
Working with the Laser Detector
(see figure D)
Under unfavorable light conditions (bright
environment, direct sunlight) and for larger
distances, use the laser detector for improved
finding of the laser beam. When working with
Switching on the tool (1.5s self-
check)
Leveling in or re-leveling
Measuring tool leveled in/ready
for operation
Self-leveling range exceeded
ADS function activated (two axes)
ADS function activated (one axis)
ADS actuated
ADS function switched off
Slope function is actuated
Hibernation mode
Battery usable
Battery voltage for ≤2 H operation
Battery empty
On
Laser/motor/LED in continuous operation
Off
Laser/motor/LED in continuously stopped
nx/s
Laser/LED blinks n times/second
All manuals and user guides at all-guides.com
Applications RL25H/RL25HV
15
with this reference
Overview of LED Indications
Laser
Rotation
Beam
of Laser
2x/s
2x/s
On
2x/s
N/C
N/C
2x/s
N/C
N/C
Off
N/C
N/C
Off
-28-
the laser detector, select rotational operation
with the highest rotational speed (600 rpm)
Measuring Over Long Distances
(see figure E)
When measuring over long distances, the laser
detector must be used to find the laser beam.
In order to reduce interferences, the laser tool
should always be set up in the center of the
work surface and on a tripod.
Working Outdoors (see figure F)
The laser detector should always be used when
working outdoors. When working on unstable
ground, mount the laser tool onto the tripod
23
. Activate the ADS function in order to
avoid faulty measurements in case of ground
vibrations or shock to the laser tool.
Green
Green
Off
2x/s
2x/s
Off
N/C
2x/s
On
On
On
Off
Alt 2x/s
Alt2x/s
On
N/C
N/C
N/C
1x/s
N/C
Off
N/C
On
N/C
N/C
N/C
N/C
1x/s
N/C
Off
Off
0.2s On
N/C
N/C
N/C
N/C
N/C
N/C
Off
Off
Off
N/C
No change from previous state
N/C**
Will indicate status if enabled or disabled
Green
Red
Red
Off
2x/s
2x/s
N/C
N/C
N/C
N/C**
N/C
N/C
Off
Off
Off
On
Off
N/C
1x/s
Off
N/C
Off
2x/s
N/C
Off
Off
N/C
N/C
N/C
N/C
Off
Off
N/C
N/C
N/C
Off
N/C
N/C
1x/s
Off
Off
On
Publicidad
Tabla de contenido
