KTM 22112929544 Instrucciones De Montaje página 33

–
Insert the key and check whether the tumblers with the num-
ber 1 are correct.
Info
The tumblers must close flush with the locking cylin-
der.
–
Replace the non-matching tumblers with ones that have the
matching number.
500517-01
Info
It is recommended that you keep the numbers of the
matching wafers so that subsequent locking cylinders
can be identically equipped.
–
Repeat the steps for chambers
six chambers are fitted with the correct wafers.
–
Insert the key.
All tumblers close flush with the locking cylinder.
500518-01
–
Mount and tighten short locking cylinder adapter
screw (both included).
The holding lug of the locking cylinder adapter (see arrow)
is located on the opposite side of the engaging plate
502805-01
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert the locking cylinder as shown in the figure.
The holding lug of the locking cylinder adapter is facing
downward.
Engaging plate
502806-01
–
Key in vertical position
The top case is closed and locked.
–
Move the key 90° to the right
The top case can be opened and closed.
–
Turn the key 45° clockwise
The handle pops up automatically.
The securing lever swings out automatically.
The top case can be opened and closed.
502807-01
The top case is released and can be mounted or removed.
B D F
, , and
bm
(included).
p. 18)
bq
engages.
G
.
H
.
I
.
ASSEMBLY 5
until the first
bl
with
bq
.
11