Stationary Wet Well Installation; Installation Dimensions - Wilo Drain TM 32 60Hz Instrucciones De Instalación Y Funcionamiento

en Installation and electrical connection
6.2.1

Stationary wet well installation

Fig. 2: Installation dimensions and switching points
Switching points
▪ 1 = Switch-on level (f)
▪ 2 = Switch-off level (g)

Installation dimensions

Dimensions in mm
Drain TM 32/7
Drain TMW 32/8
Drain TMW 32/11
Dimensions in inches
Drain TM 32/7
Drain TMW 32/8
Drain TMW 32/11
For stationary wet well installation, the pump is installed directly onto the pressure
pipe. Observe and adhere to the following points:
▪ The connected pressure pipe must be self-supporting. The pressure pipe must not be
supported by the pump.
▪ The pump may oscillate slightly during operation. These oscillations must be dissip-
ated via the pressure pipe.
16
1
2
min. a x b
a b c
350 350 300
350 350 300
350 350 330
14 14 11
14 14 11
14 14 13
d
d e
165 294
165 296
165 326
6.5 11.6
6.5 11.7
6.5 12.8
f g
237 14
250 11
280 14
9.3 0.6
10 0.4
11 0.6
WILO SE 2019-11