Troubleshooting - Biochef Aurora Manual De Usuario

Troubleshooting

Problem
1. Display does not light up
EN
2. Display is lit, but the blender
doesn't start or the program
can't be selected.
3. Alarm sounds during
operation
4. Ingredients are not all
crushed
5. Food stains on the heating
plate of the glass jug
6. Buttons are not responding
7. Display shows E1 Error
8. Display shows E2 Error
14
Solution
Check and ensure that the power cord is firmly
secured in the power socket.
Please make sure that the right jug is used for the
specific program, refer to chart 1. Press the "START/
STOP" button after selecting a program to begin.
3.1 Please clean the inside of the jug and remove
any burnt remains stuck on the base of the jug
with water and white vinegar.
3.2 Please make sure there is enough liquid in the
blender according to the specific program (see
chart 2) before starting.
4.1 Please add more water to the jug and use the
PULSE/CLEAN button to crush ingredients
or start program again (only for cold food
programs).
4.2 Check your local voltage is high enough for the
blender to use its full potential.
Clean the inside and base of the jar properly
before using. Use a mixture of vinegar and water to
remove hard stains. Please refer to recommended
food to water ratios in chart 2 and select the correct
program for the recipe before using the blender.
Please pull the plug of the blender and restart the
machine after 3 minutes.
Please place the lid on the jar securely and tight. If
the problem persists, refer to solution 6.
Please clean the inside of the jug and remove any
burnt remains stuck on the base of the jug with
water and white vinegar.
Please refer to recommended food to water ratios
in chart 2 and select the correct program for the
recipe before using the blender.