SPM BIG JUICE Manual De Instrucciones página 28

As the volume of water is set according to the
length of time during which the relative solenoid
valve remains open, the amount of water can be
increased or decreased using the "+" and "-"
buttons. The flashing of LED LS stands for the
time in seconds. The flashing of LED LDS stands
for the time in tenths of a second.
For example:
If LED LS flashes 4 times and LED LDS flashes 5
time, this means the water solenoid valve
opening time is 4.5 seconds. This time (4.5
seconds) therefore corresponds to a certain
amount of water.
- You can now find out the quantity of water
obtained by pressing button L1 (only water will
come out).
- If you wish to alter this volume, use the "+"
and "-" buttons to increase and decrease the
quantity of water, bearing in mind that each
time one of these buttons is pressed, the time is
altered by one tenth of a second (10 presses =
1 second).
- Press button L5 to confirm and save the
operation just performed.
- LED LL2 will now start flashing to confirm that
the following function has been accessed:
"modify right-hand drink water volume".
- Once again, to calibrate the device for the
correct volume of water, the instructions given
above must be followed.
- When the operation is complete, press button
L5.
- LED LL1 will now light up (on constantly, not
flashing) to confirm that the following function
has been accessed:
"modify left-hand drink product volume".
- Also in this case, the flashing of LED LS stands
for the product pump operation time in seconds
and LED LDS stands for tenths of a second.
- It is now possible to establish the exact
product quantity using button L1 (only the
product will come out).
- If you wish to increase or decrease the
product volume obtained, use buttons "+" or "-"
to make the adjustments.
- When the operation is complete, press button
L5 again.
th
Issue date: 28 Oct 2009 Revision: IMQ Page : 28/84
NOTE
Use and installation manual
- LED LL2 will now light up (on constantly, not
flashing) to confirm that the following function
has been accessed:
"modify right-hand drink product volume".
- Once again, to calibrate the device for the
correct volume of product, the instructions given
above must be followed.
- When the operation is complete, press button
L5 again.
The programming operations have now been
saved and the device switches back to the
operative position automatically, i.e.
- with LED LL1 on constantly
- with LED LL2 on constantly.
Tip:
- at the end of the programming stage, it is
advisable to set the internal switch 1 back to
"MODE OFF" so that the programming function
is fully disabled.
Still unsure as to how to program the
doses ?
Remember:
- keep button L5 pressed down for 5 seconds to
access the programming stage.
- with LED LL1 flashing, use "+" or "-" to modify
the volume of water for the left-hand pump,
then press L5;
- with LED LL2 flashing, use "+" or "-" to modify
the volume of water for the right-hand pump,
then press L5;
- with LED LL1 on constantly, use "+" or "-" to
modify the volume of product for the left-hand
pump, then press L5;
- with LED LL2 on constantly, use "+" or "-" to
modify the volume of product for the left-hand
pump, then press L5;
- The device saves the doses programmed and
returns to the operative position with LEDs LL1
and LL2 on constantly.