Qualified Personnel; Safety Symbols; Safety Precautions - Danfoss VLT Midi Drive FC 280 Guia De Instalacion

VLT® Midi Drive FC 280
1 Installation
1.1 Safety and Installation Awareness
Before starting installation, familiarize yourself with all safety guidelines and precautions in this installation guide and the operating
guide. The operating guide, design guide, and programming guide can be downloaded at www.danfoss.com/service-and-support.
PC tools and MyDrive ecoSmart

1.2 Qualified Personnel

Only qualified personnel are allowed to install, commission, and maintain Danfoss drives. For the purpose of this installation guide,
qualified personnel are trained individuals who are familiar with and authorized to mount and wire the drive in accordance with
pertinent laws and regulations. Additionally, qualified personnel must be familiar with the instructions and safety measures descri-
bed in this installation guide.

1.3 Safety Symbols

The following symbols are used in this guide:
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).

1.4 Safety Precautions

LACK OF SAFETY AWARENESS
This guide gives important information on preventing injury and damage to the equipment or the system. Ignoring this informa-
tion can lead to death, serious injury, or severe damage to the equipment.
-
Ensure the dangers and safety measures present in the application are fully understood.
-
Before performing any electrical work on the drive, lock out and tag out all power sources to the drive.
LIFTING HEAVY LOAD
Depending on the variant, the drive can weigh up to 12.5 kg. Lifting the drive incorrectly can result in injury or property damage.
-
Follow local safety regulations on lifting.
-
Check the weight of the drive. The weight is provided on the outside of the shipping box.
-
If lifting equipment is used, ensure that it is in proper working condition and can safely lift the weight of the drive.
-
Test lift the drive to verify the proper center of gravity lift point. Reposition if not level.
Danfoss A/S © 2022.06
can be downloaded at www.danfoss.com/service-and-support.
®
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E
W A R N I N G
C A U T I O N
AN41533976851001-000101 / 130R1257 | 3