Emc-Compliant Installation; Power Ratings - Danfoss VLT Midi Drive FC 280 Guia De Instalacion

VLT® Midi Drive FC 280
VLT
Midi Drive
www.danfoss.com
1
2
T/C: FC-280PK37T4E20H1BXCXXXSXXXXAX
3 P/N: 134U2184 S/N: 000000G000
0.37kW 0.5HP
4
IN: 3x380-480V 50/60Hz, 1.2/1.0A
OUT: 3x0-Vin 0-500Hz, 1.2/1.1A
5
IP20
6
Danfoss A/S, 6430 Nordborg, Denmark
Enclosure: See manual
US LISTED
5AF3 E358502 IND.CONT.EQ.
R
CAUTION / ATTENTION:
See manual for special condition/mains fuse
Voir manual de conditions speciales/fusibles
WARNING / AVERTISSEMENT:
Stored charge, wait 4 min.
Charge résiduelle, attendez 4 min.
1 Type code
2 Ordering number
3 Power rating

1.6 EMC-compliant Installation

For more information, refer to the VLT
• Use shielded cables for motor (unshielded cables in metal conduit are acceptable), brake, DC, and control wiring.
• Ensure that motor, brake, and DC cables are as short as possible to reduce the interference level from the entire system. Provide
a minimum space of 200 mm (7.9 in) between mains input, motor cables, and control cables.
• Convey the currents back to the drive using a metal mounting plate. Ensure good electrical contact from the mounting plate
through the mounting screws to the metal frame of the enclosure.
• If the shield connection points have a voltage potential difference, connect a low impedance equalizing wire parallel to the
shielded cable.
• When using relays, control cables, a signal interface, fieldbus, or brake, connect the shield to the enclosure at both ends. If the
ground path has high impedance, is noisy, or is carrying current, break the shield connection on 1 end to avoid ground current
loops.

1.7 Power Ratings

There are 3 voltage ranges for FC 280:
• 1-phase 200–240 V
• 3-phase 200–240 V
• 3-phase 380–480 V
Table 1: Enclosure Sizes and Power Ratings
Enclo- K1
sure
size
1-phase 0.37
Power
size 200–240 (0.5)
V
6 | Danfoss A/S © 2022.06
www.tuv.com
ID 0600000000
MADE IN
DENMARK
Midi Drive FC 280 Operating Guide.
®
0.55 0.75 1.1 1.5 (2.0)
(0.75) (1.0) (1.5)
4 Input voltage, frequency, and current (at low/high
voltages)
5 Output voltage, frequency, and current (at low/high
voltages)
6 Enclosure protection rating
K2 K3
2.2 (3.0) –
AN41533976851001-000101 / 130R1257
K4 K5
– –