Leveling The Ice Machine; Leg Option; Drain Pump Option - Manitowoc SM Serie Manual De Instalación, Operación Y Mantenimiento

Installation

LEVELING THE ICE MACHINE

1. Adjust the levelers close to desired height.
2. Move the bin into its final position.
3. Level the ice machine to assure that the bin door closes
and seals properly. Use a level on top of the bin. Turn the
base of each foot as necessary to level the bin.

LEG OPTION

1.Remove leg levelers from the bottom of the ice machine.
2.Screw legs into the bottom of the ice machine.
3.Screw the foot of each leg in as far as possible.
4.Move ice machine to final position.
5.Level the ice machine to assure that the bin door closes
and seals properly. Use a level on top of the bin. Turn the
base of each foot as necessary to level the bin.
14

DRAIN PUMP OPTION

Disconnect power to ice machine before proceeding.
1.Remove top cover screws and slide cover off. Remove back
panel screws and lift panel off.
2.Assemble the outlet tube and vent tube to the drain pump.
3.Plug the drain pump's wire assembly into the ice machine's
wire assembly. Slide drain pump into cavity.
4.Swap out existing Bin Drain Tube for Bin Drain Tube
packaged with drain pump.
5.Route the vent tube and outlet tube.
6.Reassemble ice machine.
NOTE: See instructions packaged with drain pump for details.
Upon activation, be sure to check all connections for water
leakage.
Part Number 000001590 Rev05 07/22
Section 2