R Otate Gear Housing; A Ttaching The Grinding Disc - SUHNER ABRASIVE UWG 11-R Documentación Técnica

3.1.3 d
ust filter
Available as an accessory. The fine mesh filter prevents
coarse particles from entering the motor housing. Re-
move regularly and clean.
3.1.4 h
And protection
Available as an accessory. Intended for work with backing
pads, sanding plates, wire brushes and support plates,
sanding pads, wire brushes and diamond Drill Bits for
tiles. Install hand guard under the additional side-mount-
ed handle.
3.2 r
otAte geAr housing
Unscrew the fastening screw of the lever. Remove the
screw, lever (with its sheet metal part) and put aside.
Unscrew the 4 gear housing screws.
Do not remove the gear housing!
Turn the gear housing to the desired position without re-
moving it. Screw in the 4 gear housing screws (b) in the
24
available threads! Tightening torque = 3.0 Nm +/- 0.3
Nm. Slide the spring that pushes the lever in position to
the side and re-insert the lever (with its sheet metal part),
and fix with the fastening screw. Tightening torque = 5.0
Nm +/- 0.5 Nm. Check the lever for correct function: it has
to be under spring tension.
3.3 A
ttAching the grinding disc
3.3.1 l
ocKing the spindle
Press in the spindle locking button and turn the spindle by
hand until the spindle locking button engages.
3.3.2 p
lAcing the grinding wheel in position
Fit the support flange on the spindle. The flange should
not turn on the spindle when properly attached!
Place the grinding disc on the support flange. The grind-
ing disc must lay flat on the supporting flange.