T Roubleshooting; C Leaning; R Epair; S Torage - SUHNER ABRASIVE UWG 11-R Documentación Técnica

4. S
ERvICE
4.1 t
rouBleshooting
The electronic signal display lights up and the load speed
decreases. There is too much load on the machine! Run
the machine in idling until the electronics signal indicator
switches off.
The machine does not start. The electronic signal display
flashes. The restart protection is active. If the mains plug
is inserted with the machine switched on, or if the power
supply is restored following an interruption, the machine
does not start up. Switch the machine off and on again.
4.2 c
leAning
It is possible that particles deposit inside the power tool
during operation. This impairs the cooling of the power
tool. Conductive build-up can impair the protective insula-
tion of the power tool and cause electrical hazards.
The power tool should be cleaned regularly, often and
thoroughly through all front and rear air vents using a vac-
uum cleaner or by blowing in dry air. Prior to this opera-
tion, separate the power tool from the power source and
wear protective glasses and dust mask.
4.3 r
epAir
If the machine strict observance of the manufacturing and
testing method the tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
Any replacement needed for the connecting line must be
installed by the manufacturer or its agent if safety risks are
to be eliminated.
4.4 s
torAge
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.5 d / e
isposAl nVironmentAl compAtiBility
This machine consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the machine unusable.
Do not throw the machine into the garbage collec-
26
/ m
aINTENaNCE
tion.
According to national regulations this machine must be
recycled in an environmentally-friendly manner.