Italjet DRAGSTER 125 Manual De Uso Y Mantenimiento página 138

- Unscrew the two screws (3) and re-
move the casing (4).
4
3
- First remove the BLACK negative
cable (5) then the RED positive ca-
ble (6) (when reassembling, connect
the RED positive cable first, then the
BLACK negative one).
- Remove the battery (7) from its
housing.
5
6
7
- Verify, with the help of a voltmeter,
that the voltage of the same is not
less than 12.5V. If not, the battery
needs a recharge cycle.
EN - 56
- Using a constant voltage battery
charger, first connect the RED posi-
tive cable to the positive terminal of
the battery then the BLACK nega-
tive one to the negative terminal of
the same.
- Always check the state of charge of
the battery before reinstalling it on
the vehicle.
The battery must be kept clean, and
the terminals greased.
- Reassemble everything by proceed-
ing in the reverse order to disassem-
bly, taking care to fit the hook (8) of
the passenger seat into the seat (9)
of the support.
2
8
9