Lighting Control - Italjet DRAGSTER 125 Manual De Uso Y Mantenimiento

5.1.u Lighting control
Front light beam control
- To check if the light is oriented cor-
rectly, place the motorcycle, with
the tires inflated to the right pres-
sure and with a person sitting in the
saddle, perfectly perpendicular to its
longitudinal axis.
- In front of a wall or a screen, 10 me-
ters away from it, draw a horizontal
line corresponding to the height of
the center of the light and a vertical
line in line with the longitudinal axis
of the vehicle.
10m
- Carry out the check, if possible, in
dim light.
- By turning on the high beam, the up-
per limit of demarcation between the
dark area and the illuminated area
must be at a height not exceeding
9/10 of the height from the ground of
the center of the projector.
- To carry out the correct adjustment,
go to an Italjet dealer.
9
X
10 X
EN - 60
Lights and direction indicators
- The motorcycle is equipped with
LED lights and indicators, if a light
does not work it must be replaced by
going to the Italjet dealer.
Diagnostic connectors
Lift the saddle to access the Diagnos-
tic Connectors (1)(2).
Connector (1) = ABS control unit
Connector (2) = Engine control unit
2 1