Klarstein MELVILLE 3 Manual De Instrucciones página 59

Note: If do it from step1 to step 2, the filter system will be removed; while if do it
from Step 2 to Step 1, the filter system will be installed. The entire filter assembly
should be cleaned once a week.
• Inspect the filters for blocking after every time the dishwasher has been used.
• By unscrewing the coarse filter, you can remove the filter system. Remove any
food remnants and clean the filters under running water.
Attention: When cleaning the filters, don't knock on them. Otherwise, the filters
could be contorted and the performance of dishwasher could be decreased.
Caring for the Dishwasher
The control panel can be cleaned by using a lightly dampened cloth. After
cleaning, make sure to dry it thoroughly. For the exterior use a good appliance
polish wax. Never use sharp objects, scouring pads or harsh cleaners on any part
of the dishwasher.
Attention: Never use a spray cleaner to clean the door panel as it may damage
the door lock and electrical components.
Cleaning The Door
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do
not use a spray cleaner of any kind.
Protect against freezing
please take frost protection measures on the dishwasher in winter. Each time after
Pashing cycles, please operate as follows.
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water
valve.
3. Drain water from the inlet pipe and water valve (Use a pan to catch the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water
in the sump.
Note: If your dishwasher cannot work because of the ice, please contact
authorised service person.
EN
59