Operation; To Fill Fuel; To Start The Product - Husqvarna TS 146XK Manual De Usuario

Introduction
WARNING:
safety chapter before you use the product.

To fill fuel

WARNING:
flammable. Be careful and refuel outdoors.
Fuel safety on page 9 .
Refer to
CAUTION:
type. Incorrect fuel type causes damage to
the product.
• Use gasoline of the correct type. Refer to
data on page 36 . For more information about the
fuel, refer to the engine manual supplied by the
engine manufacturer.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 1 in.

To start the product

To do before you start the product
WARNING:
product, carefully read and understand
the safety instructions and the operation
instructions.
1. Do a check of the engine oil level. Refer to
check of the engine oil level on page 27 .
2. Fill the fuel tank with fuel. Refer to
page 12 .
3. Disengage the freewheel mode. Refer to
product in freewheel mode on page 16 .
4. Sit in the seat in operation position.
5. Engage the parking brake. Refer to
disengage the parking brake on page 13 .
6. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck on
to
page 15 .
12

Operation

Read and understand the
Gasoline is very
Always use correct fuel
Technical
Before you operate the
To do a
To fill fuel on
To put the
To engage and
To start a warm engine
1. Sit on the seat.
2. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck on
to
page 15 .
3. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 13 .
4. Move the throttle control to the fast position.
5. Push down on the brake pedal fully and hold it down.
6. Put the ignition key into the ignition.
7. Turn the ignition key to the "START" position and
release the ignition key when the engine starts.
CAUTION:
starter continuously for more than 15
seconds for each minute.
8. If the temperature is low, let the engine become
warm before you start to cut grass.
To start a cold engine
1. Sit on the seat.
2. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck on
to
page 15 .
Do not operate the
1939 - 003 - 25.08.2022