Cutting Deck - Husqvarna TS 146XK Manual De Usuario

Cutting deck

To remove the mower
C
D
P S
Q
C
L
1. Set the attachment clutch control to the
"DISENGAGED" position.
2. Lower the attachment lift lever to its lowest position.
3. Remove the mower drive belt from the clutch pulley
(M).
4. Push the tab (L) to remove the cable (P) and slide
out of the bracket (S).
5. Remove the clutch cable spring (Q) from the idler
arm (R).
6. Disconnect the front link (E) from the mower, remove
the retainer spring and washer.
7. Disconnect the mower suspension arm (A) from
chassis pin (B) on each side of the mower deck.
8. Disconnect the rear lift link (C) from the rear mower
bracket (D) on each side of the mower deck.
9. Remove the retainer springs and the washers.
10. Disconnect the mower suspension arm and the rear
lift link on each side of the mower deck.
11. Remove the mower deck from the product.
To install the mower
Make sure that the product is on a level surface and that
the parking brake is engaged. Refer to
disengage the parking brake on page 13 .
1. Lower the mower deck lift lever to the lowest
position.
2. Make sure the mower suspension arms are pointed
forward before you move the mower below the
product.
3. Move the mower below the product until it is in the
middle.
1939 - 003 - 25.08.2022
M
E
A
B
R
D
To engage and
4. Install the clutch cable spring (Q) into the idler arm
(R).
P
S L
5. Install the clutch cable (P) into the bracket (S).
Note:
Make sure to push the tab (L) until it clicks.
6. Attach mower side suspension arms (E) to the
chassis.
E
a) Put the hole in the arm above the pin (F) on the
outer surface of the chassis.
b) Tighten with the retainer spring.
c) Do steps A and B again on the opposite side of
the product.
7. Attach the rear lift links (G).
H
a) Lift the rear corner of the mower.
b) Put the slot in the link assembly above the pin on
the rear mower bracket (H).
c) Tighten with the washer and the retainer spring.
d) Do steps A to C again on the opposite side of the
product.
R
Q
F
G
23