To Stop The Product - Husqvarna TS 146XK Manual De Usuario

To stop the product

WARNING:
engage the parking brake and remove the
ignition key before you go away from the
product.
CAUTION:
warm engine can cause burn damage to
the grass. To prevent burn damage , to the
grass, always stop the engine when you
stop the product on grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Disengage the cutting deck. Refer to
disengage the cutting deck on page 15 .
3. Put the throttle control in the slow position and let the
engine operate at idle speed for some minutes.
4. Put the cutting deck in the transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 13 .
5. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
To use the throttle control
The throttle control adjusts the engine speed and the
speed of the blades in the cutting deck.
14
Always stop the product,
The exhaust gas from the
A
To engage and
A
• Put the throttle control in the choke position (A) when
you start a cold engine. Refer to
engine on page 12 .
• Put the throttle control in the fast position (B) to
operate the engine at full speed. Always have the
throttle control in the fast position when you cut
grass.
• Put the throttle control in the slow position (C) to
operate the engine at idle speed.
To use the cruise control
Only use the cruise control for forward travel on smooth,
straight surfaces. The cruise control will disengage
automatically if the conditions for cruise control become
unsatisfactory.
1. Push the forward drive pedal (B) down. Keep the
forward drive pedal in a position that gives the
correct speed for the terrain.
A
2. Pull the cruise control lever (A) up and hold it while
you release the forward drive pedal.
3. Release the cruise control lever to engage the cruise
control.
4. Push the brake pedal or tap on the forward drive
pedal to disengage the cruise control.
B
C
To start a cold
B
1939 - 003 - 25.08.2022