To Adjust The Parallelism Of The Cutting Deck - Husqvarna TS 146XK Manual De Usuario

8. Attach the front link (L).
I
a) Start from the left side of the product.
b) Put the rod end that has a thread for the
link assembly through the front hole in the
suspension bracket (I).
c) Put the flared ends of the front link (L) into the
slots in the front mower bracket (K).
d) Install the washer and the retainer spring (J).
9. Examine the front height compared to the rear
height. If an adjustment is necessary, refer to
adjust the parallelism of the cutting deck on page
24 .
10. Install the mower drive belt onto the clutch pulley.
A
CAUTION:
belt for correct routing in all mower
pulley grooves.
11. Set the mower deck lift lever to the highest position.
12. If it is necessary, adjust the gauge wheels before
you operate the mower. Refer to
scalp rollers on page 26 .

To adjust the parallelism of the cutting deck

To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right and left
side of the product, the cutting height can be adjusted.
24
L
J
K
To
Do a check of the drive
To adjust the anti-
Adjust the cutting height on the side of cutting deck that
has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
Some models only have left side
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
Note:
Each full turn of lift adjustment nut changes
the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to lower
the cutting deck.
b) Turn the lift adjustment nut (A) to the right to lift
the cutting deck.
5. Cut some grass and examine the results. Adjust if it
is necessary.
To do a precision side to side adjustment of the cutting
deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 13 .
4. Turn the outer blade tips to align with the cutting
deck side to side.
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
5. Measure the distance (B) from the bottom edge of
the blade to the ground on the left and right side.
B
A
The blades on the
B
1939 - 003 - 25.08.2022