To Adjust The Anti-Scalp Rollers - Husqvarna TS 146XK Manual De Usuario

A
E
1. Move the mower to the highest position to access
the blade (A).
Note:
Wear protective gloves or put heavy cloth
on the blade (A).
2. Remove the blade bolt (E) by turning it
counterclockwise.
3. Install the new or resharpened blade as shown.
CAUTION:
the blade must align with the star (C) on
the mandrel assembly (B).
4. Install and tighten the blade bolt (E) fully (45-55 ft
lbs/ 62-75 Nm).
To remove the drive belt for the mower blade
P
Q
R
1. Park the product on a level surface and engage the
parking brake. Refer to
the parking brake on page 13 .
2. Remove the mower from the product. Refer to
remove the mower on page 23 .
3. Remove the screws (P) from the mandrel covers (Q).
26
B
C
D
The center hole (D) in
P
M
E
To engage and disengage
4. Remove the dirt or grass around the mandrels and
from the top surface of the mower deck.
5. Remove the mower drive belt (E) from the 4 pulleys
(R).
6. Remove the mower drive belt (E) from around the
clutch (M) on the engine shaft.
To install the drive belt for the mower blade
P
1. Install the drive belt (E) around the 4 pulleys (R).
2. Install the drive belt (E) onto the clutch pulley (M).
3. Install the mandrel covers (Q). Tighten 4 screws (P)
fully.
4. Lift the lift lever of the mower deck to the highest
position.

To adjust the anti-scalp rollers

The anti-scalp rollers keep the cutting deck in the
correct position on the ground and prevent lawn scalping
in most terrain conditions. The anti-scalp rollers are
Q
adjusted correctly when they are slightly off the ground
when the cutting deck is at the necessary cutting height.
1. Park the product on a level surface and stop the
engine.
2. Adjust the product to the necessary cutting height.
To set the cutting height on page 13 .
Refer to
To
Q
M
E
R
CAUTION:
Put the drive belt
correctly in all the grooves for the cutting
deck pulley. Risk of damage to the drive
belt if it is not installed correctly.
1939 - 003 - 25.08.2022
P
Q