Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Make sure that the engine stops when you try to
reverse with the ignition key is in the on position (A).
A
4. Start the product and engage the cutting deck again.
5. Turn the ignition switch to the ROS on position (B).
6. Make sure that the engine does not stop when you
reverse with the ignition key in the ROS on position.
To do a check of the brake
WARNING:
necessary if the product uses more than 5
ft (1.5 m) to stop at the highest speed in the
highest gear on a level, dry surface.
1. Park the product on a level, dry concrete or paved
surface. Push the brake pedal down fully and
engage the parking brake.
2. Set the freewheel control to the "transmission
disengaged" position to disengage the transmission.
3. The rear wheels must lock and skid when you try
to manually push the product forward. If the rear
wheels rotate, then brake maintenance is necessary.
4. Speak to an approved service center.
Parking brake
WARNING:
not work, the product can start to move
and cause injury or damage. Make sure that
the parking brake is regularly examined and
adjusted.
To do a check of the brake on page 8 .
Refer to
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
WARNING:
hot during and after use and when the
engine operates at idle speed. Be careful
8
B
Brake maintenance is
If the parking brake does
The muffler becomes very
near flammable materials and/or fumes to
prevent fire.
To do a check of the muffler
•
Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
To cut grass on slopes
WARNING:
instructions that follow before you use the
product.
•
To cut grass on slopes increases the risk that you
can not control the product and that it overturns. This
can cause injury or death. It is necessary to cut the
grass carefully on all slopes. If you cannot reverse
up a slope or if you do not feel safe, do not cut it.
•
Remove stones, branches and other obstacles.
•
Cut up and down the slope, not from side to side.
•
Do not move down a slope with the cutting deck
lifted.
•
Do not operate the product on ground that slopes
more than 15°.
•
Do not start or stop on a slope.
•
Move smoothly and slowly on slopes.
•
Do not make sudden changes in speed or direction.
•
Do not turn more than necessary. Turn slowly and
gradually when you move down a slope. Move at low
speed. Turn the wheel carefully.
•
Look out for and do not move across furrows, holes
and bumps. There is a higher risk that the product
overturns on ground that is not flat. Long grass can
hide obstacles.
•
Do not cut grass near edges, ditches or banks. The
product can suddenly overturn if a wheel moves
across the edge of a steep slope or a ditch, or if
an edge gives way.
•
Do not mow wet grass. It is slippery, and tires can
lose their grip so that the product skids.
•
Do not put your foot on the ground to try to make the
product more stable.
•
Move very carefully if an accessory or other object is
attached that can make the product less stable.
Read the warning
15°
>
1939 - 003 - 25.08.2022
Publicidad
Tabla de contenido
Solución de problemas
