Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
When you move the product, put the freewheel control
in freewheeling position to disengage the transmission.
Freewheel control is at the rear drawbar of the product.
1. Lift the attachment to the highest position with the
attachment lift control.
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage in the carburetor. This has
a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is not
necessary. If you use standard gasoline, do not change
to alkylate gasoline. This can cause sensitive rubber
parts to become hard. Add stabilizer to the fuel in the
tank or in the container used for storage. Always use the
mixing ratios given by the manufacturer. Run the engine
for a minimum of 10 minutes after you add the stabilizer
until it flows into the carburetor.
WARNING:
with fuel in the tank in an indoor location or
in locations with bad airflow. Risk of fire if
fuel fumes come near open flames, sparks,
or pilot lights in for example boilers, hot
water tanks and clothes dryers.
WARNING:
other flammable materials from the product
•
Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
•
When the product is worn out, send it to the dealer
or to an applicable recycling location.
1939 - 003 - 25.08.2022
Storage
Do not keep the product
Remove grass, leaves and
Disposal
2. Pull the freewheel control out and into the slot and
release to hold it in the disengaged position.
3. Do not move the product at more than two (2) mph
(3.2 km/h).
4. To reengage transmission, reverse the above
procedure.
Tow safety
•
Only use tow equipment approved by Husqvarna.
•
Use the tow bar to attach the equipment.
•
Do not tow equipment that is heavier than the
maximum permitted weight.
•
Make sure that no other persons is near the product
when you tow equipment.
•
Do not tow equipment on slopes or rough ground.
•
Operate the product at low speed when you tow
equipment.
to decrease the risk of fire. Let the product
become cool before you put it in storage.
•
Clean the product, see
19 . Repair paint damages to prevent corrosion.
•
Examine the product for worn or damaged parts and
tighten loose screws and nuts.
•
Remove the battery. Clean it, charge it, and keep it
cool during storage.
•
Change the engine oil, and discard the waste oil.
•
Empty the fuel tank. Start the engine and run it until
there is no remaining fuel in the carburetor.
Note:
Do not empty the fuel tank and carburetor if
a stabilizer has been added.
•
Remove the plugs and put about a tablespoon of
engine oil into each cylinder. Manually turn the
engine shaft to apply the oil and put the plugs back
on.
•
Lubricate all grease nipples, joints and axles.
•
Keep the product in a clean and dry area and cover
it for more protection.
•
A cover for protection of your product during storage
or transport is available at your dealer.
•
Oil, oil filters, fuel and the battery can have negative
effects on the environment. Obey the local recycling
requirements and applicable regulations.
•
Do not discard the battery as domestic waste.
•
Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
To clean the product on page
35
Publicidad
Tabla de contenido
Solución de problemas
