Husqvarna TS 146XK Manual De Usuario página 21

• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transaxle fan and cooling fins.
• Examine the cooling fan to make sure the fan blades
are clean and not damaged.
To examine the transaxle pump fluid
• Make sure that the transaxle pump fluid does not
leak.
• Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.
To adjust the front wheel toe-in and camber
The front wheel toe-in and camber is correctly set at
the factory. The front wheel toe-in and camber are not
adjustable.
• Speak to an approved service center if the factory-
set front wheel toe-in or camber is damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover on
its sides. Tilt the engine cover in the direction of the
engine and lift it to remove it from the product.
4. Install in the opposite sequence.
To replace the drive belt
1. Park the product on a level surface and engage the
parking brake. Refer to
the parking brake on page 13 .
2. Remove the cutting deck. Refer to
mower on page 23 .
1939 - 003 - 25.08.2022
A
To engage and disengage
To remove the
3. Remove the drive belt from the pulley (A) and the
clutch pulley (B).
C
B
A
D
4. Remove the drive belt from the engine pulley (C) on
the engine shaft.
5. Remove the drive belt from the rear axle pulley (D)
and the belt tension pulley (E).
6. Remove the drive belt from the product.
7. Install a new drive belt in the opposite sequence.
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove the
battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with a
wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
page 22 .
E
To replace the battery on
21