Getting Started; Tools And Fasteners Needed; Installation; Installation Overview - Levolor Sheer Shadings Manual De Instalación

GETTING STARTED

Thank you for purchasing LEVOLOR
operation, and care, your new shadings will provide years of beauty and performance.
Please thoroughly review this instruction booklet before beginning installation.

Tools and Fasteners Needed

•
Flat and Phillips head screwdrivers
•
Measuring tape and pencil
•
Power drill, / " drill bit,
3
32
and 1 / " hex driver
4
In addition, you will need fasteners designed to work with your specific
mounting surface(s).
•
#6 Hex Head Screws (Provided). Two 1
installation bracket.
•
Longer #6 Hex Head Screws (Not Provided). If using spacer blocks,
use #6 screws long enough for a secure attachment.
•
Speed Nuts and Screws (Provided). Extension brackets come with screws
and speed nuts.
•
Drywall Anchors (Not Provided). Use drywall anchors when mounting
into drywall.
#6 x 1 / " Longer #6 Hex Head Screw
1
2
Hex Head Screw for Use with Spacer Blocks
(Provided) (Not Provided)
Importance of Limit Stops on Window Shadings
Limit stops serve as the upper travel limit for the bottom rail, preventing it from
rotating around the fabric roll. Limit stops are located 6" from the ends of the
headrail or are centered on shadings less than 36" wide.
When a shading is made, the limit stops are adjusted according to the size of the
fabric roll. Occasionally, this adjustment changes during shipping or installation.
If this happens, problems can be fixed by readjusting the limit stops. See page 12
in the Troubleshooting section if shading operation is difficult or if the bottom rail
rotates around the fabric roll. Shown below are the four possible positions of limit
stops for large to small fabric rolls.
Large Fabric Roll
4
Cordless Operating System
20-0037-012_Sheer_Shadings_Cordless_F_010621.indd 4-5
Sheer Shadings. With proper installation,
®
•
Level (laser level is recommended)
•
Pliers and/or scissors (heavy-duty)
/ " screws are provided per
1
2
Speed Nut
and Screw
(Two Provided with
Each Extension Bracket)
Small Fabric Roll

Installation Overview

•
Your order will include the correct number of installation brackets for your shading
width, as shown in the table below.
•
Shading orders may also include spacer blocks or extension brackets, if they were
specified for added clearance.
— Extension brackets are used for end mount shadings, as well.
Installation Bracket
Panel Width Brackets
18" – 36" 2
36 / " – 79" 3
1
8
79 / " – 84"
1 4
8
Mounting Types and Window Terminology
If the installation brackets are mounted correctly, the rest of the installation process
follows easily. To prepare for this important first step, review the mounting types and
basic window terminology illustrated below.
Molding
Head Jamb
Jamb Jamb
Collectively, the sill and
jambs are called the
Inside Mount
"window casement."
Shading fits within
window opening.
Sill
Shim– A thin strip of material used to align parts to make them fit.
•
Refer to the appropriate page below based on your order:
— Inside Mount Page 6
— Outside Mount Page 7
— Side Mount Page 9

INSTALLATION

For Added Clearance
/ " and / "
1 1
4 2
Spacer Blocks Extension Bracket
Outside Mount
Shading mounts
outside window
opening.
5
Cordless Operating System
1/6/21 4:48 PM